It’s possible that other variables and controls on the network will hinder availability, however, availability to UDP port 500 will be the main item to verify. only for example, 52.220.151.177 is the VPS IP and 10.17.175.251 is my gateway IP. I dont have any specific configuration for network except exposing UDP ports where target and published ports are the same. We’ll need to have availability on UDP port 500 for outgoing traffic, as this is the port we’ll be using to establish our VPN connection. Containers are deployed over 3 docker swarm nodes with global mode. If you set them too low then the router will forget connections too quickly and active connections will be dropped. i found out there are few abnormal tcp/udp port in the network monitoring. UDP connections using various states, such as UNREPLIED and ASSURED as. UDP Timeout (s): 30 Image: IP Filter Settings on DD-WRT v8 Save Settings and then Reboot Router The above settings control how long it takes before inactive TCP & UDP connections are forgotten by the router. I am a using dd-wrt router and trying to get some per-user metrics, I was wondering about filtering only ESTABLISHED connections or include NEW and RELATED, I have read a lot about this last two, but I am still not sure about considering it part of used bandwidth. Also, as mentioned in the first post, if I change the source port of the UDP sender, containers start to receive traffic. Protocol (UDP) connection with the current network configuration and effi.
0 Comments
Leave a Reply. |